top of page

Multifunctional logging hoist-station for work in oil and gas wells.

The lift is adapted for various chassis options: KAMAZ, URAL, MAN, IVECO, MERSEDES, DAF.

The following types of bodies are installed on the car: marine container, reinforced frame container, isothermal (sandwich panels).

It is possible to connect connectors for a trailer and install a tow bar.

Additionally, a rear bumper is mounted with a ladder for access to the winch compartment and built-in tool boxes.

Hydraulic drive from the PTO of the transfer case of the chassis.



   The winch consists of a welded frame, a drum, a transmission, a brake system and a cable laying measuring head.


   The hydraulic drive provides:

- smooth running

- wide range of speeds

- low speed karatozh methods

- hydraulic dynamic braking


   The drive is realized in two versions:

- hydromechanical through the chain

- hydraulic built into the drum


     The braking system provides:

- smooth braking when descending

- reliable holding at stops

consists of band and hydraulic brakes.


        The cable-laying machine implements automatic forced laying of the cable on the drum with the possibility of manual adjustment from the operator's control panel.


        Quick replacement of both the entire winch and individual drums is provided.


Winch compartment


    The winch compartment accommodates: a winch, cassettes with pneumatic locks for instruments, containers for transporting radioactive sources,

reels for electric cables, floodlights for external lighting, block balance rollers and other auxiliary equipment.


   The inside of the compartment is painted with paint resistant to aggressive environments, the floor is covered with anti-slip material and is equipped with a drain pan.  

   A hatch is built into the roof of the compartment, opening 90 ° to provide visibility, as well as to replace the winch and drum. Connectors for hydraulic and electrical systems are quick-release. In the side walls, there are technological hatches for servicing the hydraulic drive of the winch.

Operator compartment

- dust and moisture resistant

- noise and heat insulated

- equipped with life support systems  

   (air conditioner, heater, ventilation)

- flexible interior layout

Control and measurement system


  Applicable measuring heads:

- WireHead for lines up to 12 mm in diameter

- SlickHeаd for lines up to 6 mm in diameter


   Visualization and recording of values:

- by depth, speed and line tension

- differential line tension

- parameters of the power plant 

- parameters and diagnostics of the hydraulic system


   Automatic modes implemented:

- maintaining the set speed and tension

  - emergency stop when reaching the limit parameters (tension, differential tension)

- shutdown when reaching the wellhead

- programmable descent by setting the intervals of depths and speeds

  - logging of tripping operations (black box)

   Installation of blowout equipment control system is possible.


Design features


- diesel generator: up to 12 kW

- hydro generator: up to 18 kW

- additional cassette holders for   downhole equipment






Cable diameter: 6 to 12 mm


Wire diameter: 1.8 to 4 mm


Drum capacity: up to 7000 m


Winch types:     

- single drum, single section

- single-drum, two-section

- double-drum


The maximum pulling force on the first two rows of winding is not less than 60 kN


Standard range of line speeds      40 - 8000 m / h


Extended range of line speeds     20 - 8000 m / h


Operating temperature range from -40 ° C to + 40 ° C


Dimensions (with chassis) no more:

- length up to 10,000 mm

- width up to 2500 mm

- height up to 4000 mm


Weight (with chassis): no more than 18  000 kg

bottom of page